The Final Filter should be turned until it is hand tight A. The Final Filter should be installed. To exit the menu, press and hold the Main Button 2 seconds. To exit the menu, press and hold the Main Button for 2 seconds. To display the next menu option, press the Main Button once. When the resistivity is below the setpoint, the Resistivity display will flash and the red Pack Alarm will be blinking see Section How to Understand Direct-Q Messages.
The Display will show F All system operations are disabled. The Distribution Pump turns on. The resistivity and temperature of the Product Water is displayed during dispensing. The resistivity and temperature remain displayed for up to 10 seconds after dispensing is stopped. The values are displayed for 5 seconds. The Distribution Pump will turn on and water will recirculate for up to 3 minutes. An auto-recirculation occurs for 3 minutes every 2 hours.
The FLU counter display will be blinking if the system has detected that there is water in the tank. The Tank Outlet Valve must be opened. HOW TO? When Pack Alarm display is blinking. SmartPak See Section Replacement When the system resistivity display is blinking.
After a system or tank sanitization. Remove the protective caps on the ports of the SmartPak. Locate the O-rings on the ports. Wet them with water. It is preferable to wet them with ultrapure water. Remove the Vent Filter L. Insert the new Vent Filter into the fitting. See Section Installation of the Vent Filter.
A clogged Final Filter can reduce the Product Water flowrate. If the Screen Filter becomes blocked with debris, then the Feedwater will not flow freely to the system. It is recommended to clean the Screen Filter twice a year or whenever it may have become clogged.
The Display will show C Allow the tank to be emptied to its lowest water level. Close the Tank Outlet Valve. This option is used when performing a system sanitization. Before emptying the tank, it is recommended to remove the Final Filter and to install the Barbed Fitting and Tygon Tubing. Millipore does not sell Hydrogen Peroxide but it is readily available through most Scientific Supply Companies.
Introduce the male connector of the clear tubing firmly into the elbow fitting E. After 1 hour Remove the Final Filter. Let the system stand for 1 hour for effective bacteria elimination. After 1 hour Check that the Tank Outlet Tubing is secured into the drain.
Open the Tank Outlet Valve to drain all the water from the tank J. Unplug the electrical cable from the UV Lamp F. Plug the electrical cable to the new UV Lamp G. Attach the UV housing with the Velcro belt I. Install the SmartPak J. Press the Main Button 4 times. Distinguishing between text specific to one or more Milli-Q systems. The water is then exposed to UV light. Your Milli-Q System should be operated according to the instructions in this manual.
Pure water requires a storage system to prevent the degradation To provide pure water for use with all of their applications, Sanitary overflow.
Blow-molded storage tank. Cylindrical shape. Product Selection Guide Millipore water purification systems incorporate advanced technologies that let you control water quality. Milli-Q Reference System A10 UV Lamp.
0コメント